Overview The S1 nozzle uses a 0.4mm bimetallic nozzle made of special material. The upper part of the nozzle is made of brass, which has better thermal conductivity, and the lower part is made of hardened steel, which has stron...

Overview The effector fan（2515） is located inside the effector and is used to cool and reduce the temperature of the throat to prevent the consumables from softening or clogging during the melting process of the throat. The fan...

Overview The driver board of the Flsun S1 motor is located on the side of the motor and is responsible for the operation and micro-step control of the motor. Product Specification Materials PCBA Color Green  

Overview The motors are three identical stepper motors installed on the top above the three axes of the printer, used to drive the tool head to move in the XYZ direction. Includes motor , motor cable and synchronized wheel. Pr...

Overview The PTFE tube connector is a component used to connect PTFE tubes and is installed above the effector module so that consumables can enter the throat correctly. Product Specification Quantity 3 pcs Materials Plasti...

Overview The drying chamber cable is an 11pin cable used to connect the effector and the motherboard. Product Specification Plug Double-ended 11pin Length 400mm    

Overview The control board fan (4010) is located inside the upper case and is used to cool the motherboard and driver board to prevent the board from shutting down due to overheating. Product Specification Voltage / Operati...

Overview The air filter fan (9025 fan) is located on the upper right side of the cavity and is used to filter harmful gases in the cavity. Product Specification Voltage / Operation Voltage 36 V Operation Current 0.2 A Mat...

Overview Melt extrusion printers will generate VOCs while printing because the heating temperature of ABS, PC, PA and other materials is relatively high, resulting in more VOCs. Materials such as PLA with lower melting points p...