Ordenar
Características
Más relevantes
Más vendidos
Alfabéticamente, A-Z
Alfabéticamente, Z-A
Precio, menor a mayor
Precio, mayor a menor
Fecha: antiguo(a) a reciente
Fecha: reciente a antiguo(a)
$24.99
En stock
Overview
The S1 nozzle uses a 0.4mm bimetallic nozzle made of special material. The upper part of the nozzle is made of brass, which has better thermal conductivity, and the lower part is made of hardened steel, which has stron...
$89.00
$139.00
En stock
Overview
High-pressure cooling fan: Compared to the S1, this high-performance cooling fan provides efficient heat dissipation with lower noise levels. Enjoy a quieter workspace with noise reduced to only 55 dB.
Large Diame...
Quick add
$19.99
En stock
Overview
The effector fan（2515） is located inside the effector and is used to cool and reduce the temperature of the throat to prevent the consumables from softening or clogging during the melting process of the throat. The fan...
$31.89
En stock
Overview
The motors are three identical stepper motors installed on the top above the three axes of the printer, used to drive the tool head to move in the XYZ direction. Includes motor , motor cable and synchronized wheel.
Pr...
$7.49
En stock
Overview
The PTFE tube connector is a component used to connect PTFE tubes and is installed above the effector module so that consumables can enter the throat correctly.
Product Specification
Quantity
3 pcs
Materials
Plasti...
$19.49
En stock
Overview
The drying chamber cable is an 11pin cable used to connect the effector and the motherboard.
Product Specification
Plug
Double-ended 11pin
Length
400mm
$16.49
En stock
Overview
The control board fan (4010) is located inside the upper case and is used to cool the motherboard and driver board to prevent the board from shutting down due to overheating.
Product Specification
Voltage / Operati...
$13.48
En stock
Overview
The air filter fan (9025 fan) is located on the upper right side of the cavity and is used to filter harmful gases in the cavity.
Product Specification
Voltage / Operation Voltage
36 V
Operation Current
0.2 A
Mat...
$13.99
Agotado
Overview
Melt extrusion printers will generate VOCs while printing because the heating temperature of ABS, PC, PA and other materials is relatively high, resulting in more VOCs. Materials such as PLA with lower melting points p...
Showing 12 of 22 products
Load more items
Etiquetas de filtro
S-Series Accessories - flsun3d
High speed 3D-printer accessories for S machine
See More +
See Less -
RECENTLY VIEWED PRODUCTS